What are Common Lighting Issues?
Posted on December 13, 2013
House exterior with porch walkay over a pond and lighting in the woods
Outdoor lighting can beautify a property, add to its safety and security, and extend the enjoyment of the outdoors well into the night. However, if the landscape lighting system doesn’t work, then none of these aspects can be achieved. Depending on the quality of the system that was initially installed, there can be a few or many common lighting issues that can and will occur over the lifetime of a lighting system, and severity can range from a burned-out light bulb to fire-hazard situations.
Typically, the most common lighting issue is a light bulb that has gone out. If the light has burned out, it is a simple fix and only takes a few moments to replace the old bulb with a new one. A light could also go out because of a bad connection. It’s only a matter of tracking down the bad connection and repairing or replacing it. Also, a light could go out because the socket has become corroded. The most responsible repair for a lighting professional in this situation is to go ahead and replace the light fixture.
Another common lighting issue is some or all of the lights are out. This is usually indicative of an electrical short. A quick and easy solution is if the ground fault interrupter (GFI) has tripped a breaker and simply needs to be reset. (What is a GFI? https://www.homeadvisor.com/article.show.Ground-Fault-Interrupters-Keep-up-the-Code.14182.html). Another quick and easy solution is that the clock timer or photo sensor have been improperly set, causing the lights to come on at incorrect times. Also, the lights could be out due to high levels of amperage exiting the transformer. In this situation, amperage on each fixture can be tested to narrow down the location of the short.
Sometimes bulbs seemingly become dim. This is a symptom of improper voltage at the light fixture. Every extra light added to a landscape lighting system and every added foot of wire, leads to voltage drop. If the connections are not watertight, there will be even more voltage drop. Perhaps there is too much demand on the transformer and another transformer needs to be installed to power all of the lights. According to VOLT, a landscape lighting supply store, voltage drop is one of the five most common mistakes made while installing landscape lighting. (https://www.landscapelightingworld.com/Top-5-Low-Voltage-Outdoor-Lighting-Installation-Mistakes-a/162.htm)
Overtime, connections can be pulled tight and even pull apart. It is good practice for a lighting professional to leave extra wire near connections (keep it slack) so that as the ground expands and contracts, or as trees grow taller, or as shrubs grow out, there is enough wire to be pulled. If the connections are too tight to begin with, as time goes by, these connections will undoubtedly fail.
One easy thing that a homeowner can do to steer clear of avoidable repairs is to be careful when working in the garden or lawn. It is in the best interest of the homeowner to review the outdoor lighting plan for their property and to take a close look at their garden and lawn before digging to ensure that the wires on the plan are in fact located in the same spot outside. Avoiding a cut wire can save the homeowner money on a service call. In addition, keeping shrubs trimmed around lights will ensure that the light is not interrupted and reaches its intended target.
How Do I Protect My Home and Property From Excess Water?
Posted on December 12, 2013
Protecting your home and property from excess water is very important as water is a very destructive element and a force to be reckoned with when it is where it doesn’t belong. Most often, excess water can come from either rainfall events or your sprinkler system. The first step is determining how the excess water is getting to where it doesn’t belong. Does your property slope towards your house? Does water from the roof fall directly next to the house? Is your sprinkler system not operating properly? No matter the location of the excess water, the solution always involves redirecting the water.
If your property slopes towards your house, or if you have low areas that collect water, consider re-grading the slope or redesigning your flowerbeds and shrub gardens. If this is not an option for your property, consider installing a sub-grade drainage system, such as a French drain, that will allow the excess water on your property to drain to the street or to a collection point.
For situations where water from the roof falls directly next to the house, a realistic solution is to install rain gutters around your house. It’s great to have gutters at the front and back of the house, but the sides need it too. According to Phillips Gutters (www.phillipsgutters.com), “Directing water is for the benefit of your roof, your brick and siding, your foundation, and your landscaping.” If you already have rain gutters around your house, regularly clean them out along with the down spouts to ensure that when it does rain, your gutter system will function properly and protect your home.
A poorly functioning sprinkler system can also add excess water to your property. A leak in your system will cause large amounts of water to pool and pond near your house or in other areas on your property. Misaligned spray heads may be spraying directly onto your house or fence, causing damage. Water should only be touching soil or vegetation. Your sprinkler system may be set to water too often or for too long. Our clay-rich soils can’t absorb water at a fast rate, so give it time for the water to soak in before starting another cycle. Regularly check your sprinkler system for leaks and problems with the spray heads – you may be able to catch a small problem before it becomes a big one. Also, set your sprinkler system to run according to the watering restrictions set by your city or the North Texas Municipal Water District (NTMWD). Currently in these winter months, the NTMWD allows watering once every two weeks and stated “Landscape experts point out that lawns become dormant during winter months and require less water.” (www.ntmwd.com)
Although every situation is different, and every home and property is unique, there is a solution out there that will help to protect your home and property from excess water.
Protect and Get the Most Out of Your Landscape Lighting Investment
Posted on October 22, 2013
A landscape lighting system can add security and showcase your property and landscaping for many years when properly maintained. Due to the fact that landscape lighting fixtures are generally blended into the landscaping for a seamless appearance during the day, they are prone to being obstructed by new plant growth and maturing vegetation.
A good example of plant obstruction is the address for the property. Most well-planned landscape lighting systems have an up-light strategically placed to illuminate the address of the house at night. When we perform system maintenance, these are up-lights are obstructed almost every time. It doesn’t take much growing time for the whole effect and safety of a fixture to be lost.
Path lights are an excellent way to illuminate steps and walks for safety and showcase your landscaping at night; however, when plants, bushes, etc. grow tall around them, it significantly reduces the spread (area illuminated) and performance of the fixture.
Up-lights are one of the most used fixtures in a landscape lighting system and are placed in the ground, typically with a stake, and are directed upwards onto a tree, wall, decoration, etc. It is common for these fixtures to get mulch, leaves, grass clippings, etc. on the top of the lens causing the light emitted from them to be dim or completely obstructed. These fixtures are also prone to building a hazy film or coating on the lens from the treated water used in the sprinkler system landing on them. This also reduces the effect of the light significantly. A chemical solution like CLR will usually clean the lens to look as good as new, making the light almost twice as bright in most cases.
Lastly, landscape lighting installed in the trees is a great effect but requires the most attention and cost to maintain. The lighting cable is usually stapled or secured to the tree trunk and limbs. As the tree grows, it will pull and stretch these cables, literally pulling them apart and out of the fixture. This can be solved and prevented by an annual check of your landscape lighting system.
After spending the money on a landscape lighting system, it is worth taking the little extra time here and there to make sure that you are getting the most out of your fixtures. You’d be surprised how a little pruning and cleaning here and there can rejuvenate the effectiveness of your system.
Landscape Lighting Estimates
Posted on October 10, 2013
We get a lot of questions about why there is such a wide range of estimates for low voltage landscape lighting systems from one contractor to the next. There are several variables that influence the cost of a landscape lighting system. These include the quality and cost of the fixtures, amount and gauge of the electrical wire, type of connections used, type and quality of bulbs used [halogen or light-emitting diode (LED)], and quality of the installation itself.
Let’s start with the fixtures themselves. There are some very poorly constructed fixtures on the market that are not designed to last very long. We like to call them “builder grade.” These poor quality fixtures are a good way to bring down the cost to make estimates more appealing to the customer; however, these fixtures are installed in locations where they are subjected to the weather and get wet every time the sprinkler system operates. The inexpensive fixtures are usually constructed of composite materials and are not designed to be repaired; rather they are designed to be replaced, costing the customer more money. On the other hand, there are many well constructed, high-quality fixtures. They are constructed of a cast bronze or brass body. They also seal better, keeping the moisture out, which prolongs the life of the socket and the bulb. They also have replacement parts available and are designed to be repaired in the field.
The next crucial element of the landscape lighting system is the overall design. A properly designed system is going to use a significant amount more wire than most systems that are just thrown in by contractors who don’t have an understanding of electrical design. There is a lot more to it than just running a wire and attaching lights to it. When getting proposals for your landscape lighting system, and more importantly before you give a deposit for a new system, ask for a copy of the design as well as an electrical chart of the circuits. If your contractor cannot issue one or says that it is not important, we would recommend that you don’t issue a deposit and get another contractor. Down the road, if a system has been installed incorrectly, it is usually best and easiest to just start over from scratch. There are many contractors out there that are performing lighting work that have no business in doing so.
When it comes time to decide on a contractor for the installation of a landscape lighting system, be sure to ask them a lot of questions about the products they are using and how much will be used. Being able to compare apples to apples rather than lemons to apples will surely help you to make a better decision, and more importantly, to feel comfortable with that decision.
Are Stage 4 Restrictions in the Future for Our Sprinkler Repair Plano Service Area?
Posted on September 10, 2013
Watering restrictions are no joke and they are about to become very serious! The summer of 2013 is the first summer where watering restrictions have entered into Stage 3 for our sprinkler repair Plano service area. Stage 3 watering restrictions basically consist of watering once a week; however, ET/Smart Controllers and drip irrigation may water without restriction.
Although the summer will hopefully soon be starting to wind down, our Pearson Sprinkler Company service area is still in danger of entering Stage 4 watering restrictions. Of the cities located in our service area, the ones most in danger of entering Stage 4 watering restrictions include those cities which obtain water from the North Texas Municipal Water District (NTMWD).
According to the NTMWD Water Conservation and Drought Contingency and Water Emergency Response Plan dated March 2008, there are several items that would trigger a move into Stage 4 watering restrictions. These include:
- Water demand is projected to approach or exceed the limit of the permitted supply.
- The storage in Lavon Lake is less than 35 percent of the total conservation pool capacity. (See discussion below)
- NTMWD’s storage in Jim Chapman Lake is less than 35 percent of NTMWD’s total conservation pool capacity. (See discussion below)
- The supply from Lake Texoma, the East Fork Raw Water Supply Project, or some other NTMWD source has become severely limited in availability. (See discussion below)
- The Sabine River Authority has indicated that its Upper Basin water supplies used by NTMWD (Lake Tawakoni and/or Lake Fork) are in a severe drought or emergency.
- Water demand exceeds the amount that can be delivered to customers.
- Water demand for all or part of the delivery system seriously exceeds delivery capacity because the delivery capacity is inadequate.
- Supply source becomes contaminated.
- Water supply system unable to deliver water due to the failure or damage of major water system components.
Based on a review of September 6, 2013 data from the United States Army Corps of Engineers (USACE) website, Lake Lavon is 52.8 percent full of the total conservation pool capacity, thankfully well off 35 percent.
Jim Chapman Lake is at a staggering level of 35.6 percent full of the total conservation pool capacity, a mere 0.6 percent from triggering Stage 4 watering restrictions!
In addition, the water supply from Lake Texoma, where the NTMWD usually obtains at least 25 percent of its water, has been completely cut off from the NTMWD since 2009 as a new pipe is being built from the lake to the Wylie Water Treatment Plant due to a zebra mussel infestation in the original connecting pipe. Lake Texoma straddles the border of Texas and Oklahoma and Texas has rights to 50 percent of Lake Texoma’s total conservation capacity. Based on the Texas share, Lake Texoma is 99.2 percent full of the total conservation pool capacity. There is all of this water in Lake Texoma just waiting for NTMWD customers to use! The new pipe is projected to be completed by the end of March 2014.
The NTMWD sets the watering restrictions for the cities which purchase its water and each city is required to implement the restrictions. NTMWD Stage 4 watering restrictions include the following mandatory items which we believe would most directly affect our sprinkler repair Plano service area:
- The use of treated water for the irrigation of new landscaping is not permitted.
- Washing of vehicles except as necessary for health, sanitation, or safety reasons is not permitted.
- Landscape watering is not permitted. Exception – foundations and trees may be watered for 2 hours on any day with a hand-held hose, a soaker hose, or a dedicated zone using a drip irrigation system. ET/Smart irrigation systems and drip irrigation systems are not exempt from this requirement.
- Permitting of new private pools is prohibited. Pools already permitted may be completed and filled with water. Existing pools may add water to maintain pool levels but may not be drained and refilled.
We at Pearson Sprinkler Company are torn between what to wish for. On one hand, if we wish for a rainy fall, Stage 4 watering restrictions will likely be avoided; however, business has the potential to slow down. On the other hand, if we wish for a dry fall, we will more than likely be forced to enter in to Stage 4 watering restrictions. We guess that the best we can do for our sprinkler repair customers in Plano is to do our best to educate and provide useful information and hope that the new pipeline from Lake Texoma to Wylie gets completed on time, alleviating water supply pressures.